3.11.10 Serial port COM1 setting
1. Baud rate
Set the communication speed. Maximum 56,000 bps can be set.
2. Bit length
Set the bit number of the communication data to 7 or 8.
3. Stop bit
Set the stop bits number to 1 or 2.
4. Parity
Presence or absence of parity check. In the case of presence, select even number or odd
number.
5. Driver type
Set to either the RS232, RS485 Single or RS485 Multipoint.
6. RS485ID
Set the identification number in the RS485 Multipoint. (1 to 127)
3.11.11 Serial port COM2 setting
Refer to 1 to 4, and 6 in Section 3.11.10, "Serial port COM1 setting".
5. Driver type is set to either RS485 Single or RS485 Multipoint.
3.11.12 Date/Time setting
Set the present date/time in the built-in clock.
3.11.13 EdCentra setting
Set the network configuration to connect EdCentra.
3.11.14 Factory setting
The set value of the factory setting is shown in Table 6.
To Next Page
Loading...
