EMC-PARTNER TRA3000 S - Page 135

EMC PARTNER AG
135/162
Command REN (REmote Enable)
Explanation: change-over into Remote Control Mode.
No query possible
Argument:
no argument
Command GTL (Go To Local)
Explanation: change-over into Local Mode. (manipulation from the TRA front panel)
No query possible
Argument:
no argument
Command E (Error number)
Explanation: query of Remote Error-Code.
The remote error-code will be reset by the command E?
Argument: no argument
Answer: Integer with the follow codes
0: no error
1: Command only allowed in remote
2: unknown command
3: inpermissible argument
4: no query allowed
5: command only allowed in standby-mode
8: timeout at transmitting end
16: parity error at transmitting end
32: overflow of the input buffer
64: other errors
Error-Code 1 to.5 always relate in any case to the preceding command.
The Error-Codewill be reset after each query.
Example: VNOM 4ç*"6
E?
Answer: 3