EMC-PARTNER TRA3000 S - Page 5

TRANSIENT3000
5/162
5.4.2
TRA3000 equipped with EXT-TRA3000 D 55
5.4.3 DIP DC (Interrupt) without PS3 power supply source of EMC PARTNER 55
5.4.4 Example 56
5.5 Hints for the test set up according to IEC standards 57
5.5.1 Test set up EFT 57
5.5.2 ESD test set up 58
5.5.3 Test set up SURGE 59
5.5.4 Test set-up for table top equipment 61
5.6 Practical testing sequence 62
6 TESTING WITH THE TRA3000 F-S-D-V-C 63
6.1 Quick start of the TRA3000 F-S-D-V-C 63
6.1.1 Selection of a language: Deutsch, François, Italian, Espagnol and Beep function 65
6.1.2 Protocol possibilities 66
6.1.3 EUT - Power and EUT - Control 67
6.2 Editing test parameters 68
6.2.1 Overview of programmable test with the TRA3000 F-S-D-V-C 68
6.2.2 Nominal values setting 71
6.2.3 Editing „Ramp“ 82
6.3 EMC test operation „RUN Mode“ 90
6.4 Operating System Displays 95
6.4.1 Rolling information lines 95
6.4.2 Service access and firmware upload 96
6.4.3 Web Server 97
6.5 Protocol Management 98
6.5.1 Customizing the Protocol Header 98
6.5.2 Optimizing Protocol storage 99
7 MAINTENANCE AND SERVICING 103
7.1 Maintenance 103
7.2 Cleaning front and rearplate 103
7.3 Verification versus Calibration 103
7.3.1 Verification Example IEC 61000-4-4 Ed.2 103
7.3.2 Calibration Example IEC 61000-4-4 Ed.2 103
7.4 Verification of the TRA3000 F-S-D-V-C by the user 103
7.4.1 EFT 103
7.4.2 ESD 104
7.4.3 SURGE 104
7.4.4 Interruption 104
7.4.5 Variation 104
7.5 Calibration of the TRA3000 F-S-D-V-C by EMC PARTNER AG 105