Emerson DSM314 - Page 111

User Manual Chapter 4
GFK-1742F Jan 2020
Configuration 100
Configuration
Parameter
Description
Values
Default
Units
Reference
Section
12 = 4 Axis
Number of Axes
setting
Axis 1 Mode
Axis 1 Control Mode
Analog Servo
Digital Servo
Analog Servo
N/A
1.03
Axis 2 Mode
Axis 2 Control Mode
Analog Servo
Digital Servo
Auxiliary Axis
Analog Servo
N/A
1.03
Axis 3 Mode
Axis 3 Control Mode
Analog Servo
Auxiliary Axis
Auxiliary Axis
N/A
1.03
Axis 4 Mode
Axis 4 Control Mode
Disabled
Analog Servo
Auxiliary Axis
Disabled
N/A
1.03
Local Logic
Mode
The Local Logic
Engine mode
Disabled
Enabled
Disabled
N/A
1.04
Total Encoder
Power
Encoder power
requirements
RX3i: 0.000 through
0.500
90-30: 0 through 2.5
0
RX3i: Amps
90-30: Watts
1.05
Motion Program
Block Name
The motion program
name to execute on the
module
Name must be 20
characters or less
and begin with a
letter or underscore
(_). Only
alphanumeric
characters and non-
consecutive
underscores are
allowed.
<blank>
N/A
1.06
Local Logic
Block Name
The local logic program
name to execute on the
module
<blank>
N/A
1.07
CAM Block
Name
The CAM block name to
execute on the module
<blank>
N/A
1.08
I/O Scan Set
(RX3i only)
The scan set (as defined in
the CPU's Scan Sets tab)
to be assigned to this
module.
1 through 32
1
N/A
1.09