User Manual Chapter 10
GFK-1742F Jan 2020
Introduction to Local Logic Programming 260
Figure 124: Hardware Configuration DSM314 Axis#1 Tab
The above steps must be repeated for P003 and P004.
B.
Select the Axis #2 tab and input 18 in Return Data 1 Mode. This tells the DSM
that you want to return parameter registers. In Return Data 1 Offset, enter a 3.
This tells the DSM to return parameter P003.
C.
On the Axis #2 tab, enter in 18 in Return Data 2 Mode and 4 in Return Data 2
Offset to tell the DSM to return P004.
Note: Select Return Data 2 Axis 2 is returned in %AI memory offset 41 while Return Data 2 for Axis 2 is
returned in % AI offset 43.
Figure 125: Hardware Configuration DSM314 Axis #2 Tab
To Next Page
Loading...
