User Manual Chapter 10
GFK-1742F Jan 2020
Introduction to Local Logic Programming 272
You also need to configure the DSM with the values calculated above for User Units to
Counts and top speed. The example also configures Axis direction and high position limit.
These are optional. Consult chapter 4 for information on these configuration fields. To add
these values, type the following into the fields on the Axis#1 tab.
UserUnits: 600
Counts: 8192
High Position Limit: 599 (Optional, causes position to roll over every revolution)
Velocity Limit: 30000
Axis Direction: Reverse (Optional causes servo to turn clockwise)
Figure 136: Hardware Configuration DSM314 Axis#1 Tab
To Next Page
Loading...
