User Manual Chapter 15
GFK-1742F Jan 2020
Using the Electronic CAM Feature 346
Figure 159: Create New CAM Block
Creating the new block opens up an edit field that allows you to name the block. The rules
for naming a CAM block are:
•
Only the characters A-Z, a-z, 0-9, and _ (underscore symbol) are allowed.
Consecutive underscores are not allowed.
•
The block name must begin with a letter or underscore symbol.
•
A block cannot have the same name as another block that exists in an open folder.
•
A CAM block name may contain up to twenty characters.
Figure 160: CAM Block Screen
To Next Page
Loading...
