User Manual Chapter 15
GFK-1742F Jan 2020
Using the Electronic CAM Feature 351
Figure 166: CAM Editor Example (Linear Cycle CAM)
There are numerous other features in the editor. These include being able to define
additional sectors that each have a different curve fit method. These editor features are
discussed in the programming software’s on-line help. Please refer to this source for
additional information.
Step 6: Specify the CAM Type
For this example, the CAM will be Linear Cyclic, as discussed previously. Use the following
procedure:
•
In the Project tab of the Navigator, right-click a CAM profile. The short-cut menu
appears.
•
From the short-cut menu, choose Properties. The Inspector opens showing the CAM
profile's properties.
•
In the Inspector, click the arrow in the CAM Type field. The CAM Type drop-down list
appears.
•
Choose ‘Linear Cyclic CAM’ from the list (Figure 167).
To Next Page
Loading...
