User Manual Chapter 15
GFK-1742F Jan 2020
Using the Electronic CAM Feature 358
You also need to indicate to Axis #1 that it will use the Axis #2 commanded position as its
CAM Master source. To do this select, the Axis #1 tab in hardware configuration. Go to the
CAM Master Source data entry field. From the drop-down box, select Cmd Position 2. This
will configure Axis #1 to use the Axis #2 commanded position as its CAM master source
(Figure 172). While in this tab, change the Home Mode to Move + and OverTravel Switch to
Disabled.
Figure 172: CAM Slave Master Source Selection
To Next Page
Loading...
