User Manual Chapter 15
GFK-1742F Jan 2020
Using the Electronic CAM Feature 357
In this example, the Local Logic program will control CTL01 and CTL08. Because CTL01 and
CTL08 are used to signal the Motion Programs, you must configure these CTL bits to be
under Local Logic Control. To do this, access the CTL Bits tab in the hardware configuration
and set CTL01 Config and CTL08 Config to Local_Logic_Controlled. The resulting Hardware
Configuration screen is shown in Figure 171.
Figure 171: Hardware Configuration 90-30 rack DSM314 CTL Bits Tab
To Next Page
Loading...
