User Manual Appendix H
GFK-1742F Jan 2020
Using VersaPro with the DSM314 491
This will insert a new profile into the library named “profile1” as seen in Figure 253.
Figure 253: New Profile Creation
You can then rename this profile to a name more suitable to the application if desired. The
naming rules are:
•
Any alpha-numeric character or the underscore ( _ ) symbol may be used.
•
The first character in a profile name must be a letter.
•
A profile name cannot be more than 20 characters long.
•
A profile is referenced by name in a VersaPro motion program. NOTE: VersaPro is not
case-sensitive when referencing a profile name.
To Next Page
Loading...
