54 DCM00044 REV. 14
5.1 Technical Specifications
5.1.1 Requirement Specifications
The Ultraweld L20 Actuator requires compressed air. The factory air source must be “clean
and dry air”, that is, without moisture or lubricants. The Actuator requires 70 psi minimum
pressure for operation and cooling, and can require up to 80 psi maximum, depending on
the application. The following table lists environmental specifications for the ultrasonic
welder. The following table lists environmental specifications for the ultrasonic welder.
All electrical input power connections are to the Power Supply.
5.1.2 Performance Specifications
The following table details some of the performance specifications associated with the
Ultraweld L20 Actuator.
Table 5.1 Environmental Specifications
Environment Range
Humidity 30% to 90% non condensing
Ambient Temperature +5º C to +40º C (+41º F to +104º F)
Storage / Shipping Temperature -13º F to +131º F (-25º C to +55º C)
Operating Altitude 1000 m (3280 ft)
IP Rating 2X
Table 5.2 Ultraweld L20 Actuator Performance Specifications
Height Encoder Accuracy ±0.05mm (0.002 in)
Maximum Stroke 48mm / 1.9 in
To Next Page
