DCM00002 REV. 16 47
5.6 Advanced Weld Settings Screen
Figure 5.5 Advanced Weld Settings screen
Advanced Weld Settings
This screen allows access to the advanced options features defined below. These values
will normally reflect the default settings made in Configuration mode. Values set from this
screen will only effect the preset currently in use.
Press one of the following options for this screen:
AFTERBURST TIME
To change the amount of time (sec) of a short burst of ultrasonic energy that begins after
the ultrasonic welding cycle. See 5.35 Typical Keypad Entry Screen.
AFTERBURST DELAY
To change the amount of time (sec) between the completion of the ultrasonic weld cycle
and the start of the afterburst. See 5.35 Typical Keypad Entry Screen.
SQUEEZE TIME
To change the amount of time (sec) between when the horn engages the component(s)
and when the delivery of ultrasonic energy occurs. See 5.35 Typical Keypad Entry Screen.
PREBURST
To change the amount of time (sec) of a short burst of ultrasonic energy that begins after
the squeeze time and before capturing the Pre-Height. Used when welding magnet wire. It
helps to break up the insulation around the copper, and provide a small cooling period
before the weld takes place. See 5.35 Typical Keypad Entry Screen.
HOLD
To change the amount of time (sec) the components remain held under weld pressure
after the delivery of ultrasonic energy. See 5.35 Typical Keypad Entry Screen.
QUICK AFTER BURST
To enable/disable the Quick After Burst function.
EXIT
To return to Weld Settings. See 5.4 Weld Settings Screen.
To Next Page
Loading...
