DCM00002 REV. 16 59
5.17 Sequence Name and Edit Screen
Figure 5.16 Sequence Name and Edit screen
Sequence Name & Edit Screen*
Sequence names are created and edited from this screen. Once the name is created the
user may choose the presets which make up the sequence. Up to 50 sequences may be
stored.
*Not available on Ultrasplice 40 & ST 40 actuators.
Press one of the following options for this screen:
UP, DOWN, LEFT or RIGHT ARROWS
To navigate cursor over the desired character in the selection box.
KEY
To add the character in the name window.
SPACE
To add spaces in name window.
ARROW (lower right hand of screen)
To backspace one character.
CLEAR
To erase all characters in the name window.
ENTER
When satisfied with the sequence name. The Sequence Steps screen will appear and
presets used in the sequence may be selected. See 5.18 Sequence Steps Screen.
To Next Page
Loading...
