DCM00002 REV. 16 71
5.28 System Configuration Screen (Next, Next)
Figure 5.27 System Configuration screen (Next, Next)
System Configuration Screen (Next, Next)
This screen allows access to other configuration settings.
Press one of the following options for this screen:
HARDWARE
To set information feedback devices. See 5.29 Transducer Configuration Screen.
SEQUENCE ERROR
To set error handling options when running in Sequence mode. See 5.30 Sequence Error
Screen.
BARCODE
To enable/disable barcode functionality.
GATEWAY*
To enable/disable Gateway functionality.
EXIT
To return to System Configuration. See 5.24 System Configuration Screen (Next).
*Available only on Ultraweld 20. Refer to Data Interface Gateway Manual 1026686 for
setting up the Module RS232 to Ethernet.
To Next Page
Loading...
