34 DCM00044 REV. 14
4.1 About Installation
This chapter is intended to help the installer with the basic installation and setup of your
new Ultraweld L20 system. This chapter will bring the reader to the point at which the
system is functionally “ready to weld”.
International safety labels are found on the power supply and actuator. Those that are of
importance during installation of the system are identified in the figures in this and other
chapters of the welding system manuals.
CAUTION Heavy Object
The Ultraweld L20 Actuator and related components are heavy.
Handling, unpacking, and installation can require help or the use of
lifting platforms or hoists.
To Next Page
Loading...
