DCM00044 REV. 14 31
3.2 Receiving and Unpacking
Branson Metal Welding actuator units are carefully checked and packed before dispatch. It
is recommended, however, that you follow the inspection procedure below after delivery.
To inspect the Ultraweld L20 Actuator when it is delivered:
Table 3.2 Receiving and Unpacking
Step Action
1 Verify that all parts are complete according to the packing slip.
2
Check the equipment immediately after delivery to ensure that it has not
been damaged during transport.
3 Report any damage claims to your carrier immediately.
4
Determine if any component has become loose during shipping and, if
necessary, tighten screws.
NOTICE
If the goods delivered have been damaged during shipping, please
contact the forwarding agent immediately. Retain packing material
(for possible inspection or for sending back the unit).
CAUTION Heavy Object
The Actuator and the Controller are heavy. Handling, unpacking, and
installation might require assistance of a colleague or the use of a
lifting device.
To Next Page
Loading...
