DCM00002 REV. 16 69
5.26 Password Changing Screen
Figure 5.25 Password Changing screen
Password Changing Screen
This screen is used to create passwords that control operator access to the touchscreen
commands.
Level 1 passwords restrict access to the following screens:
Settings Quality
Sequence Splices
Teach Adjust
Level 2 passwords restrict access to the Configuration. Maintain and Diagnostic screens.
In order to use a Level 1 password a Level 2 password must be set.
Level 3 passwords restrict access to the following screens:
Quality limits key pads Make a new splice Teach Button
Weld setting key pads
A Level 1, Level 2, or Level 3 password which is set to “0” turns password protection off.
The factory settings for the controller are “0” for Level 1, 3 and “2677” for Level 2.
To change a password the user must first enter the current password. If password
protection is off, enter “0” as the current password. A new password may then be entered.
A password may be up to 4 numbers Max.
Press one of the following options for this screen:
LEVEL 1
To change the Level 1 password setting.
LEVEL 2
To change the Level 2 password setting.
LEVEL 3
To change the Level 3 password setting.
RESET
To return to System Configuration. 5.24 System Configuration Screen (Next).
To Next Page
Loading...
