66 DCM00002 REV. 16
Press one of the following options for this screen:
ANY MIN/MAX % VALUE*
To select an allowable deviation to be applied to the sample average. Availability of
Preheight and Height settings is actuator dependent.
*Available only on Ultraweld 20, Ultraweld 40, MTS 20, & ST 40 actuators equipped with a height encoder which
is set to on.
(MODE)
To toggle between Standard and Auto teach modes.
(QTY)
To enter a quantity for the sample set. The sample set may include up to fifty welds. In
Auto mode the sample set has a fifteen weld minimum.
TEACH
To put the controller in teach mode.
EXIT
To return to System Configuration. See 5.21 System Configuration Screen.
To Next Page
Loading...
