DCM00044 REV. 14 3
1.1.2 Symbols Found on the back of the product
The Ultraweld L20 Actuator has several warning labels on it to alert the user of items of
concern or hazard. The following warning symbols appear on the L20 Actuator:
Figure 1.1 Safety Label Found on the Front of the Actuator
Figure 1.2 Safety Labels Found in the Back of the Unit
Figure 1.3 Safety Labels Found Near Bolt-Down Locations
NOTICE
NOTICE is used to address practices not related to personal injury. It
contains important information. It might also alert the user about
unsafe practices or conditions that can damage equipment if not
corrected.
To Next Page
Loading...
