Emerson Vilter MicroVission - Setting up the Compressor Sequencing Table

D − 16
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Appendix D • Compressor Sequencing Setup
Setting up the Compressor Sequencing Table
When the network connections to all the compressors
have been tested, then they can be added to the com-
pressor sequencing table of the MicroVission panel.
Reference Figure D-13.
Under the Equipment Column compressors name will be
listed, Set the priority combo box value for every com-
pressor in which you want to be Priority #1, #2, #3 etc.
When the MicroVission panel has added the compres-
sors to the sequencing algorithm and the MicroVission
panel has veried communication to every other com-
pressor, the Status column will show a question mark as
shown in Figure D-13.
Figure D-13. Setting up Compressors for Sequencing