D − 14
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Appendix D • Compressor Sequencing Setup
Figure D-11. Testing Connection in Compressor Sequencing Screen
Testing the MicroVission panel connections
After the MicroVission panels have been added to the
Devices List, it is a good idea to test out the network con-
nections to these devices. Reference Figure D-11.
Highlight the MicroVission panel that you’d like to test.
Then press the “Test Connection” button. An informa-
tional window will appear showing if the test was suc-
cessful or not. If the test is unsuccessful, double check
the Ethernet settings to ensure that those parameters in
the MicroVission panels are congured properly.
Continue to select the compressors listed in the Devices
List and test the connection of all compressors.
To Next Page
Loading...
