Emerson Vilter MicroVission - Section 19 • Compressor Sequencing Overview; Compressor Sequencing Table

19 – 1
Section 19 • Compressor Sequencing
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Overview
The compressor sequencing screen is where more than
one MicroVission panel can be sequenced in network
using Modbus TCP. These settings dene how the com-
pressors should control sequenced MicroVission panels.
This feature is enabled from the Conguration Screen,
see Section 12 for Compressor Sequencing.
Compressor Sequencing Table
The compressor sequencing table’s menu allows the op-
erator to view and adjust settings that are used for com-
pressor sequencing, see Figure 19-1.
Equipment:
• This is read only value this can be changed by
changing the compressor name from congu-
ration screen. This is updated depending on de-
vices shown in Devices List Page. This contains
names of all the compressors in the network
communicating with the other compressor. The
same Equipment name might be congured
with the different IP Address in the sequencing
table.
IP Address:
• This is read only value this can be changed by chang-
ing the IP address from the conguration screen. This
contains the IP addresses of all the connected devices
corresponding to the Equipment List.
Priority:
• This denes the priorities of the compressors on the
network. This priority will decide the sequence in
which compressors will be turned on and off during
the sequence cycle. The lower the priority number,
the greater the priority of the compressor.
Status Symbols:
• The Status Symbols show status of the compressors
on the sequencing table, see Table 19-1 for further
details.
Figure 19-1. Compressor Sequencing Screen – Sequencing Setup Screen