Emerson Vilter MicroVission - Available Devices

13 – 2
Section 13 • Data Backup
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Available Devices
This window displays any USB ash drive plugged into
one of the MicroVission USB ports. Once one of the
available devices is selected, the contents of the select-
ed device will be displayed in the “Select Folder / File”
window. If the plugged in USB ash drive is not showing
up, operator can try pressing the “Refresh” button at the
bottom of the screen.
NOTE
Unfortunately, not all USB ash drives are compatible
with the MicroVission and might not be shown in the
available devices list.
Select Folder/File
• This window displays the folders and les contained in
the USB ash drive selected in the “Available Devices”
window. The information from the MicroVission will
be stored into a .zip le. So, a zip le will have to be
selected to load the data or overwritten when saved.
Once a zip le is selected, the name will be shown in
the “Filename” window.
Unmount
• By Pressing the Unmount button, any USB drive se-
lected in the “Available Devices” window will be dis-
connected from the operating system and can be
safely removed from the USB port.
Back
• The Back button returns the operator to the preced-
ing window display of les and folders.
Filename
• This window is where you can give a name to a saved
backup le. This eld will automatically be populated
if le is selected in the “Select Folder/File” window.
Settings
• Using this table, the operator can choose to save
or load all or part of information contained in the
MicroVission.
Data Items
• Using these checkboxes, the operator can choose to
save or load all or part of information contained in the
MicroVission according to the selection of options.
Figure 13-2. Data Backup Screen - Migrate and Factory Reset