multi N/C 2100S Safety instructions
11
2 Safety instructions
For your own safety and to ensure error-free and safe operation of the analyzer
multi N/C 2100S, please read this chapter carefully before using the appliance.
Observe all safety notes listed in this user manual and all messages and displayed by the
control and analysis software on the monitor.
2.1 Safety markings on the analyzer
Safety symbols have been attached to the analyzer and accessories whose content must
always be observed.
Damaged or missing safety symbols can cause incorrect actions leading to personal
injury or material damage! The safety symbols must not be removed! Damaged safety
symbols must be replaced without delay!
The following safety symbols have been attached to the analyzer and accessories:
smoking prohibited!
Warning against dangerous
electrical voltage
hazardous substances
surface
Warning against corrosive
substances
housing switch off the
device and disconnect the
mains plug from the
mains connection.
The device contains restricted substances. Analytik Jena
AG guarantees, that those hazardous substances may not
leak out during the next 25 years when the device is used
in accordance with its intended purpose.
2.2 Technical condition
The analyzer corresponds in its design and construction to the current state of the art
technology. Unauthorized modifications or changes, especially such that affect the
safety of the staff and the environment, are generally not allowed.
To Next Page
Loading...
Need help?
General
