Endress+Hauser Analytik Jena multi N/C 2100S User Manual

Fault removal multi N/C 2100S
92
8.2 Error messages in multiWin
Error code Error message
VERS Communication error - incorrect command set between PC and device!
Cause Remedy
 the internal and external program versions
do not match
 update the internal and external program
VERS1 Communication error - analyzer
Cause Remedy
 analyzer not switched on  switch on analyzer
 multiWin started too early  only start multiWin after 30 sec
 analyzer not connected to PC  check connection between analyzer and PC
 incorrect COM port set in multiWin at the
external computer
 check set interface at the external computer, if
necessary select different interface in multiWin with
menu command Configuration / interface
-6 Analysis device is busy
Cause Remedy
 analyzer > 10 min in the busy state  initialize analyzer
-5 communication error - analyzer STAT, MESS, STEP or INIT
Cause Remedy
 Communication errors  initialize analyzer
-4 Communication error - analyzer
Cause Remedy
 Communication errors  check interface cable
 initialize analyzer
-3
-2
-1
command from the analyzer CRC error CRC error
invalid command from the analyzer
Cause Remedy
 Communication errors  initialize analyzer

Endress+Hauser Analytik Jena multi N/C 2100S Specifications

General

Brand	Endress+Hauser
Model	Analytik Jena multi N/C 2100S
Category	Measuring Instruments
Language	English