Safety instructions multi N/C 2100S
16
Avoid dust formation and inhalation of dust when handing the quartz glass wool
during filling of the combustion tube.
Auxiliary and operating materials as well as their containers may not be disposed in
domestic waste or enter the sewage system or the soil. The applicable regulations for
disposal of these materials must be meticulously observed.
Ensure good room ventilation in working rooms.
2.5.6 Safety instructions - service and repair
The analyzer is usually serviced by the customer service department of Analytik Jena AG
or its authorized and trained specialist personnel.
Independent servicing can misadjust or damaged the analyzer. Therefore, the operator
may only carry out the tasks listed in the chapter "Service and care".
The following has to be observed:
The exterior of the analyzer may only be cleaned with a damp, not dripping, cloth
after the analyzer has been switched off.
Any service and repair work at the analyzer may usually only be carried out in the
switched-off condition (unless stated otherwise).
Service tasks and the replacement of system components (removal of the
combustion tube, catalyst replacement) must only be carried out after a sufficiently
long cooling down phase.
Prior to servicing or repair the energy and gas supplies must be disconnected and the
analyzer must be v vented!
Only use original accessories and original replacement parts from Analytik Jena AG.
The notes in the chapter "Service and care" must be observed.
All protective equipment must be reinstalled correctly immediately after completion
of the service and repair work and be checked for operation!
2.6 Behavior during emergencies
The analyzer must be switched off from the power switch (on the equipment backplate)
and the power supply has to be disconnected from the mains in case of dangerous
situations or accidents.
Because a rapid response can save lives during an emergency, the following has to be
ensured:
The operating staff must be familiar with the location of safety equipment, accident
and danger alarms as well as first aid and rescue equipment as well as their
handling.
The operator is responsible for the respective training of the operating staff.
All equipment for first aid (first-aid kit, eyewash bottles, stretcher, etc.) as well as
equipment for firefighting (fire extinguishers) must be within reach and easy to
access. All equipment has to be in a sound condition and should be checked
regularly.
To Next Page
Loading...
Need help?
General
