Specifications multi N/C 2100S
112
11.2 Standards and directives
The analyzer belongs to protection class I.
The casing has protection class IP 20.
The analyzer conforms to the safety standards
EN 61010-1
EN 61010-2-081
EN 61010-2-010
EN 61010-2-051 (for operation with sampler)
The analyzer has been checked for interference emission and resistance.
It meets the requirements for interference emission of
EN 61326-1 (EN 55011 Group 1, Class B)
It meets the requirements of interference resistance of
EN 61326-1 (requirements for use in basic electromagnetic environments)
The analyzer has been tested for environmental compatibility and meets the
requirements of
ISO 9022-3
ISO 9022-2
The analyzer is built and tested according to standards that meet the requirements of
EU directives 2014/35/EU and 2014/30/EU. The analyzer leaves the factory in a sound
condition as far as technical safety is concerned. To maintain this condition and to
ensure safe operation, the operator must strictly observe the safety and operating
instructions contained in this manual. For accessories which have also been supplied,
and system components from other manufacturers, their operating instructions should
be referred to.
The device contains restricted substances (according to directive "Management Methods
for the Restriction of the Use of Hazardous Substances in Electrical and Electronic
Products"). Analytik Jena AG guarantees, that those hazardous substances may not leak
out during the next 25 years when the device is used in accordance with its intended
purpose.
Safety class and safety
type
Device safety
EMC compatibility
Environmental
compatibility
EU directives
Chinese directives
To Previous Page
Loading...
Need help?
General
