Endress+Hauser OXY5500 - Appendix A: Specifications

Endress+Hauser A–1
Appendix A: Specifications
Table A–1 OXY5500 analyzer specifications
Application Data
Target Components
O
2
Principle of Measurement Fluorescent Quenching
Typical Measurement Ranges
OP-9
1
1. Analyzer ships with one sensor. Additional sensors are optional.
OP-6
1
OP-3
1
0 to 200 ppmv (default)
0-10 to 10-1,000 ppmv
2
User setting
2. Accuracy specification applies to concentrations up to 300 ppmv.
0 to 5%
0-1 to 0-5%
User setting
0-20%
0-10 to 0-20%
User setting
Lower Limit of Detection 0.5 ppmv 20 ppmv 300 ppmv
Accuracy at 20 to 25
° C
±5% of Reading ±3% of Reading ±2% of Reading
Repeatability ±1% of Reading
Measurement Update Time Programmable Sampling Rate (default 30 seconds)
Temperature Range
3
(Configurable)
3. Configurable based on OP-9, OP-6, OP-3 probe constants. Refer to the Calibration Certificate.
1) 0 °C to 60 °C (0 °F to 140 °F)
2) -20
°C to 50 °C (-4 °F to 122 °F)
Sample Inlet Pressure 140 to 275 KPaG (20 to 40 PSIG) to sample panel regulator
Sample Pressure Range 800 to 1400 mbara
Maximum Probe Pressure 275 KPaG (40 PSIG)
Sample Flow Rate Typical 1.0 SLPM (2.1 SCFH)
Recommended Calibration
Two-point calibration in oxygen-free environment (nitrogen)
and a second span point (cylinder gas). Validate with O
2
in N
2
reference (cylinder gas).
Electrical & Communications
Input Power
(Voltage and Max. Power)
108 to 253 VAC, 50/60 Hz; 5.3W at 120 VAC; 6.6W at 240 VAC or
9 to 30 VDC (CSA), 18 to 30 VDC (IEC/ATEX); 4.7 W at 24 VDC
Communication Analog: Qty (2) 4-20mA sourcing power outputs and (1) 4-20
mA input (sample pressure)
Fieldbus: RS-232C, RS-485, Ethernet 10/100 with Modbus
Output Relays: Qty (2) 250 mA max load (Concentration and
Fault Alarms)
USB 2.0 works with Service Software only
4 GB Internal Memory with Internal Data Logging
LCD Display Concentration, Temperature, Sample Rate, Data Logging, Diag-
nostics, plus Full Menu for Setup, Calibration, etc.
Service Software
• Windows software.
• Connected via USB port.
• Download data logs, trend and monitor, calibrate and trouble-
shoot.