OXY5500 Optical Oxygen Analyzer BA02195C
4
–2 Endress+Hauser
Operation Overview
The screens and menus described in this chapter are used to program and
operate the OXY5500. Links have been included to assist in navigating through
the instructions. Refer to “Conventions used in this manual” on page 1-2,
which explains hot links and how to use them. Other conventions used in this
chapter to describe user actions and to assist in software or manual navigation
include:
• Underlined text: Used to show click-able program buttons in the
software.
• ALL CAPITAL LETTERS: Used to indicate screens or windows viewed
throughout the software program.
• Italic text: Used to indicate software fields that can be edited.
• “Bold text”: Used to indicate links to other sections or chapters in
the manual.
After the analyzer has been initialized, the MAIN MENU screen displays. Refer
to Figure 4–2.
The OXY5500 display is divided into three sections: status bar, main screen and
navigation bar.
The status bar shows:
• Time: The OXY5500 has a 24-hour clock setting.
The OXY5500 must be calibrated before use. Refer to
“Performing a two-point calibration” on page 4-41.
If the power to the analyzer is disabled, the Time and Date will be
set to 0 on start-up. A warning message will display in the Status
bar as shown in Figure 4–3.
Figure 4–2 Main menu screen
STATUS BAR
MAIN SCREEN
NAVIGATION BAR
To Next Page
Loading...
