OXY5500 Optical Oxygen Analyzer BA02195C
4
–12 Endress+Hauser
Select Yes and stop the measurement to proceed with the Analog Output
settings.
The ANALOGUES menu is divided into four screens: 4-20mA INTERFACE
SETTINGS, 4-20mA VALUES, CONCENTRATION ALARM RELAY (LS2) and
4-20mA CALIBRATION. Refer to “Analog Output Settings (Analogues)
Menu Options” on page 4-53.
• Press the buttons to navigate between input fields.
To enter editing mode
1. Press to enter editing mode.
2. Change the setting or value (one digit at a time) using the
buttons.
3. Press the again to save editing changes.
To exit editing mode
1. Press to cancel and exit editing mode.
All changes will be applied after the next measurement period.
Figure 4–15 Message window - Stop
measurements during configuration
To Next Page
Loading...
