Endress+Hauser OXY5500 - Calibration

BA02195C OXY5500 Optical Oxygen Analyzer
Endress+Hauser 4
–33
2. Press the Next button in the upper right corner of the screen, then
click .
The display will change to the CALIBRATION DATA screen. Refer to Fig-
ure 4–35. If a calibration was performed with a previously connected
sensor, the data from that calibration is shown.
Calibration
Calibration pressure and temperature are set from the CALIBRATION
SETTINGS and CALIBRATION TEMPERATURE screens, as shown below.
Setting calibration pressure
Refer to Figure 4–36 for a view of the CALIBRATION SETTINGS screen. The
following instructions provide setting information.
On the Calibration Certificate (refer to Figure 4–34 on page 4–32),
“T0” is shown under the Calibration Data section, Temperature
column as Cal0 and Cal2nd.
On the Calibration Certificate, “pATM” is shown as “Atmospheric
Pressure” under the Calibration Specifications section during Cal0
and Cal2nd. Refer to Figure 4–34 on page 4–32.
Figure 4–35 Calibration data screen