Endress+Hauser Proline Promag H 300 - Page 105

Proline Promag H 300 PROFINET Commissioning
Endress+Hauser 105
Parameter Prerequisite Description Selection / User
entry
Factory setting
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
*
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Temperature
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
None
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
*
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Temperature
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
None
0% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
Country-specific:
• 0 l/h
• 0 gal/min (us)