Endress+Hauser Proline Promag H 300 - Totalizer

Operation Proline Promag H 300 PROFINET
130 Endress+Hauser
Parameter Prerequisite Description User interface
Corrected conductivity One of the following conditions is met:
• Order code for "Sensor option", option
CI "Medium temperature
measurement"
or
• The temperature is read into the
flowmeter from an external device.
Displays the conductivity currently
corrected.
Dependency
The unit is taken from the Conductivity
unit parameter (→  87).
Positive floating-point
number
Temperature One of the following conditions is met:
• Order code for "Sensor option", option
CI "Medium temperature
measurement"
or
• The temperature is read into the
flowmeter from an external device.
Displays the temperature that is
currently calculated.
Dependency
The unit is taken from the
Temperature unit parameter
(→  87).
Positive floating-point
number
Density – Displays the current fixed density or
density read in from an external device.
Dependency
The unit is taken from the Density unit
parameter.
Signed floating-point
number
11.4.2 Totalizer
The Totalizer submenu contains all the parameters needed to display the current
measured values for every totalizer.
Navigation
"Diagnostics" menu → Measured values → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable
→  131
Totalizer value 1 to n
→  131
Totalizer status 1 to n
→  131
Totalizer status (Hex) 1 to n
→  131