Endress+Hauser Proline Promag H 300 - 11.5 Adapting the measuring device to the process conditions; 11.6 Performing a totalizer reset

Operation Proline Promag H 300 PROFINET
134 Endress+Hauser
Parameter overview with brief description
Parameter Prerequisite Description User interface
Output frequency 1 to n In the Operating mode parameter, the
Frequency option is selected.
Displays the value currently measured
for the frequency output.
0.0 to 12 500.0 Hz
Pulse output 1 to n The Pulse option is selected in the
Operating mode parameter parameter.
Displays the pulse frequency currently
output.
Positive floating-point
number
Switch status 1 to n The Switch option is selected in the
Operating mode parameter.
Displays the current switch output
status.
• Open
• Closed
Output values for relay output
The Relay output 1 to n submenu contains all the parameters needed to display the
current measured values for every relay output.
Navigation
"Diagnostics" menu → Measured values → Output values → Relay output 1 to n
‣
Relay output 1 to n
Switch status
→  134
Switch cycles
→  134
Max. switch cycles number
→  134
Parameter overview with brief description
Parameter Description User interface
Switch status Shows the current relay switch status. • Open
• Closed
Switch cycles Shows number of all performed switch cycles. Positive integer
Max. switch cycles number Shows the maximal number of guaranteed switch cycles. Positive integer
11.5 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using theSetup menu (→  85)
• Advanced settings using theAdvanced setup submenu (→  109)
11.6 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers