Endress+Hauser Proline Promag H 300 - Commissioning; 10.1 Function check; 10.2 Switching on the measuring device; 10.3 Connecting via FieldCare

Commissioning Proline Promag H 300 PROFINET
84 Endress+Hauser
10 Commissioning
10.1 Function check
Before commissioning the measuring device:
‣
Make sure that the post-installation and post-connection checks have been performed.
• "Post-installation check" checklist→  27
• "Post-connection check" checklist →  46
10.2 Switching on the measuring device
‣
After a successful function check, switch on the measuring device.
 After a successful startup, the local display switches automatically from the startup
display to the operational display.
If nothing appears on the local display or a diagnostic message is displayed, refer to
the section on "Diagnostics and troubleshooting" →  139.
10.3 Connecting via FieldCare
• For FieldCare →  68 connection
• For connecting via FieldCare →  70
• For the FieldCare →  71 user interface
10.4 Setting the operating language
Factory setting: English or ordered local language
X X X X X X XX X
20.50
Operation
Setup
Main menu
0104-1
Display language
English
Español
Français
Display language
English
Deutsch
Ã
0104-1
Ã
Español
Français
Display language
English
Deutsch
0104-1
Betrieb
Setup
Hauptmenü
Sprache
Deutsch
0104-1
XXXX
1.
2.
3.
4.
A0029420
 25 Taking the example of the local display