Endress+Hauser Proline Promag H 300 - Factory Setting; Startup Configuration

System integration Proline Promag H 300 PROFINET
82 Endress+Hauser
9.3.4 Factory setting
The slots are already assigned in the automation system for initial commissioning.
Assigned slots
Slot Factory setting
1 Volume flow
2 Mass flow
3 Corrected volume flow
4 Flow velocity
5…10 –
11 Totalizer 1
12 Totalizer 2
13 Totalizer 3
9.3.5 Startup configuration
If startup configuration is enabled, the configuration of the most important device
parameters is taken from the automation system and used. The following configuration is
taken from the automation system.
Startup configuration
(NSU)
• Management:
• Software revision
• Write protection
• System units:
• Mass flow
• Mass
• Volume flow
• Volume
• Corrected volume flow
• Corrected volume
• Density
• Temperature
• Conductivity
• Sensor adjustment
• Process parameter:
• Damping (flow, conductivity, temperature)
• Flow override
• Filter options
• Low flow cut off:
• Assign process variable
• Switch-on/switch-off point
• Pressure shock suppression
• Empty pipe detection:
• Assign process variable
• Limit values
• Response time
• External compensation:
• Temperature source
• Density source
• Density value
• Diagnostic settings
• Diagnostic behavior for diverse diagnostic information