Endress+Hauser Proline Promag H 300 - 10.5.12 Configuring the Low Flow Cut off

Commissioning Proline Promag H 300 PROFINET
106 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
100% bargraph value 3 A selection was made in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
0
Value 4 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
*
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Temperature
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
None
* Visibility depends on order options or device settings
10.5.12 Configuring the low flow cut off
The Low flow cut off wizard systematically guides the user through all the parameters
that must be set to configure low flow cut off.
Navigation
"Setup" menu → Low flow cut off
‣
Low flow cut off
Assign process variable
→  107
On value low flow cutoff
→  107
Off value low flow cutoff
→  107
Pressure shock suppression
→  107