Entec ETMFC610 - Communication; Protocol Setup

Multi-Function Control ETMFC610 http://www.entecene.co.kr
130
EN
HANCED
TEC
HNOLOGY
7.2. Communication
Place the curser on “COMMUNIATION” in GLOBAL SETTING menu, press [ENT] button to
move into this menu. Communication and its related elements are sent in this menu and it has sub-
menu as below.
NOTE :
Changed set value must be saved to be applied. When escaping from
“*.SAVE
SETTING”
menu or moving to high menu, changed set value is saved by ‘Changed set value
saved message’.
7.2.1. Protocol Setup
Place the curser on “PROTOCOL SETUP” in COMMUNICATION menu, press [ENT] button to
move into this menu. Communication protocol of ETMFC610 is set and it has sub-menus as below.
ETMFC610 supports DNP3, IEC60870-5-101, IEC60870-5-104, MODBOUS, IEC61850, SNTP,
SNMP, ETIMS and Multi-Bit Communication protocol. This menu may be changed depending on
User’s request. Each protocol setting details are as below.
[COMMUNICATION]
>1.PROTOCOLS
2.PORTS
3.DIALUP MODEM
4.FTP-SSL
5.WIFI
6.EVENT&ETC
*.SAVE SETTINGS
[PROTOCOL
S
]
>1.DNP3
2.IEC60870-5
3.MODBUS
4.IEC61850
5.SNTP
6.SNMP
7.ETIMS
8.MULTI-BIT