Entec ETMFC610 - 7 Global Setting; General Setting

Multi-Function Control ETMFC610 http://www.entecene.co.kr
65
EN
HANCED
TEC
HNOLOGY
7. GLOBAL SETTING
Place the curser in “GLOBAL SETTING”, press [ENT] button, it is moved to GLOBAL
SETTING. This menu consists of “GENERAL” menu and “COMMUNICATION” menu.
7.1. General Setting
This menu is to set general setting required to operate multi-function control ETMFC610, and Sub-
menu consists of below picture.
NOTE :
Changed set value must be saved to be applied. When escaping from
“*.SAVE
SETTING”
menu or moving to high menu, changed set value is saved by ‘Changed set value
saved message’.
[GLOBAL SETTING]
>1.GENERAL
2.COMMUNICATION
[
GENERAL
]
>1.SYSTEM
2.EVENT RECODER
3.MONITERING
4.LOOP CONTROL
5.PASSCODE
6.PLC
7.DEVICE
*.SAVE SETTING