EasyManua.ls Logo

Entec ETMFC610 - Protection Type Functions

Default Icon
372 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multi-Function Control ETMFC610 http://www.entecene.co.kr
13
EN
HANCED
HNOLOGY
2.5. Protection Type Functions
Phase/Ground/Neg Seq’ Time Overcurrent Protection (+/-)
Function..................................................................... DISALBE/TRIP/TRIP&ALARM/ALARM
Phase/Ground/Negative Sequence Pickup Level ...... 10 to 1600A in steps of 1A
*. The setting range of Pickup Level can vary
according to H/W option.
Dropout Level ........................................................... 96 to 98% of Pickup
Curve Type ................................................................ Total 62 Curves
ANSI/IEEE : Normally, Very, Extremely
IEC : Normally, Very, Extremely, Long Time Inverse, Short Time Inverse
EB : Normally, Very, Long Time Very Inverse, Extremely Inverse
Definite Time : DEF-1s, DEF-10s
Korean(Kepco) Curve : N1, N2, N3, N4
User programmable curves : USER-1, USER-2, USER-3, USER-4
McGraw-Edison : Non-Standard Curves 32
Fuse Non-standard Curve : 3 (RI, HR, FR)
Time Dial ................................................................... 0.01 to 15.00 in steps of 0.01
Time Adder ................................................................ 0.00 to 600.00s in steps of 0.01s
Minimum Response Time ......................................... 0.00 to 10.00s in steps of 0.01s
Reset Type ................................................................. INSTANTANEOUS/LINEAR
Low Set Definite Time .............................................. OFF, 0.01 to 600.00s in steps of 0.01s
Pickup Level Accuracy.............................................. 5%
Timing Accuracy ....................................................... Max. 50 at 0 trip time delay
5% of trip time or ± 20
Phase/Ground/Neg Seq’ Instantaneous Overcurrent Protection(+/-)
Function..................................................................... DISALBE/ENABLE
Phase/Ground/Neg’ Pickup Level ............................. 10 to 20,000A in steps of 1A
Dropout Level ........................................................... 95 to 98% of Pickup
Time Delay ................................................................ 0.00 to 600.00s in steps of 0.01s
Active Sequence ........................................................ 1~5shot in steps of 1shot
Pickup Level Accuracy.............................................. 5%
Timing Accuracy ....................................................... Max. 50 at 0 trip time delay
5% of trip time or ± 20

Table of Contents