Multi-Function Control ETMFC610 http://www.entecene.co.kr
16. Function of File Transfer Protocol
Without connecting ETIMS interface software, ETMFC610 is possible to patch upgrade firmware
and to download COMTRADE(COMmon Format for Transient Data Exchange) format files on
operator PC. For this function is used, it is essential to use TLS(Transport Layer Security) that
universial FTP utility is installed on PC. By recommendation of universial FTP utility, there are
FileZilla, WinSCP.
16.1. Patching firmware to upgrade
Process of firmware patch is as follows;
1) Connect between PC and ETMFC610
Connect between PC and ETMFC610 using Ethernet cable. The Ethernet cable should be wired at
ethernet port(EN1 or EN2) for Ethernet on side panel of ETMFC610.
2) Access ETMFC610 through FTP utility
After executing FTP utility, enter IP address of ETMFC610 required to patch firmware and No. 21
for the number of port on TLS settings of FTP utility. IP address of ETMFC610 refers to setting
values on “GLOBAL SETTING/ COMMUNICATION/ PORT SETUP / EHTERNET/ IP Addr
Oct1~ 4”.
Password refers to ‘Admin PW’ setting on “GLOBAL SETTING / COMMUNICATION / FTP-
SSL / Admin PW”. Access “/home/entec_system/PACKAGE” on the FTP utility.
3) Firmware Upgrade through ETIMS Interface Software
Upload a file named ‘UPDATE.fw’ on directory. DOES NOT REVISE the file name. If the file
name does not correspond, patching firmware is not supported. After completed to upload the file
on the directory, patching firmware starts automatically. Changed firmware version is checked on
device or through interface ETIMS interface software after patch process is successfully finished.
For reference this function supports on ETIMS interface software, too.
To Next Page
Loading...