Entec EVRC2A-N6-NT - Page 49

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
39
ENHANCED TECHNOLOGY
3.3.4. Setting Save
To save all changed values, steps are as follows;
Move to “PRIMARY, ALTERNATE or EDITBANK SETTING / SAVE SETTINGS” and
follow each step as below.
PRIMARY, ALTERNATE or EDITBANK SETTING / SAVE SETTINGS
①
②
③
1) Type Passcode and press [ENT] key
2) If Passcode is correct, screen ②(Left) appears; otherwise screen ①
(Left) appears again.
3) If screen ② appears, press [ENT] key to save changed value.
NOTE :
The changed setting can be effective after it is saved.
If the “save” procedure is canceled, the setting keeps previous
value.
However, by EVRC2A version 5.30, if a setting related with
communication is changed and then saved, the changed setting is
applied after rebooting.
SAVE SETTING
SETTING VALUE SAVE
<ENT>:SETTING SAVE
ENTER PASSCODE
0000