RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
79
ENHANCED
TECHNOLOGY
5.5. Clear Saved Data
In order to reset saved data, go to “PRIMARY, ALTERNATE or EDITBANK SETTING /
RELAY SETUP / CLEAR SAVED DATA” menu.
RELAY SETUP / CLEAR SAVED DATA
Clear Saved Data
Select item for clearing and then press [ENT] button.
If procedure of clearing is completed, the message, “EVENT CLEAR
SUCCESS” is shown.
y Fault Cycle
y System Status
y Load Profile
y Diagnostic
y Max Demand
y Energy
y Counter
y Wear Monitor
y Fault Trip
y P-Quality
Counter
y P-Quality
Event
y Communication Buffer
y All Saved Data
NOTE :
It is recommended to have Backup data because
Cleared(Deleted) data can not be recovered.
5.6. Factory Debug
This menu is for Manufacturer’s maintenance purpose.
FAULT CYCLE DATA
!! DATA CLEARED !!
FAULT CYCLE DATA
PRESS ENT TO CLEAR
[CLEAR SAVED DATA]
>1.Fault Cycle
>2.System Status
>3.Load Profile
>4.Daignostic
>5.Max Demand
>6.Energy
>7.Counter
>8.Wear Monitor
>9.Fault Trip
>10.P-Quality Count
>11.P-Quality Event
>12.Comm’ Event
>13.All Saved Data
To Next Page
Loading...