Configuring the Switch
3-56
3
Web – Click Security, AAA, Summary.
Figure 3-36. AAA Summary
CLI – Specify the required port and apply the accounting list to it.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer Protocol
(HTTPS) over the Secure Socket Layer (SSL), providing secure access (i.e., an
encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on the switch.
However, you cannot configure both services to use the same UDP port.
• If you enable HTTPS, you must indicate this in the URL that you specify in your
browser: https://device[:port_number]
Console(config-if)#show accounting 4-95
Console(config)#
To Next Page
Loading...
