System Management Commands
4-47
4
logging trap
This command enables the logging of system messages to a remote server, or limits
the syslog messages saved to a remote server based on severity. Use this
command without a specified level to enable remote logging. Use the no form to
disable remote logging.
Syntax
[no] logging trap [level]
level - One of the syslog severity levels. Messages sent include the
selected level up through level 0. (Refer to the table on
page 4-45.)
Default Setting
Level 3 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and sets
the minimum severity level to be saved.
• Using this command without a specified level also enables remote logging,
but restores the minimum severity level to the default.
Example
clear log
Use this command to clear messages from the log buffer.
Syntax
clear log [flash | ram]
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on power
reset).
Default Setting
Flash and RAM
Command Mode
Privileged Exec
Example
Console(config)#logging trap 4
Console(config)#
Console#clear log
Console#
To Next Page
Loading...
Need help?
General