Enterasys Matrix-V V2H124-24 - Address Table Commands; Mac-Address-Table Static; Table 4-56. Show LACP System ID Output Contents; Table 4-57. Address Table Commands

Command Line Interface
4-174
4
Address Table Commands
These commands are used to configure the address table for filtering specified
addresses, displaying current entries, clearing the table, or setting the aging time.
mac-address-table static
Use this command to map a static address to a destination port in a VLAN. Use the
no form to remove an address.
Syntax
Syntax
mac-address-table static mac-address interface interface
vlan
vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-32)
• vlan-id - VLAN ID (Range: 1-4093)
• action -
- delete-on-reset - Assignment lasts until the switch is reset.
- permanent - Assignment is permanent.
Table 4-56. Show LACP System ID Output Contents
Field Description
Channel group A link aggregation group configured on this switch.
System Priority* LACP system priority for this channel group.
System MAC Address* System MAC address.
* The LACP system priority and system MAC address are concatenated to form the LAG system ID.
Table 4-57. Address Table Commands
Command Function Mode Page
mac-address-table static Maps a static address to a port in a VLAN GC 4-174
clear mac-address-table dynamic Removes any learned entries from the forwarding
database
PE 4-175
show mac-address-table Displays entries in the bridge-forwarding database PE 4-176
mac-address-table aging-time Sets the aging time of the address table GC 4-175
show mac-address-table
aging-time
Shows the aging time for the address table PE 4-177