Enterasys Matrix-V V2H124-24

Authentication Commands
4-101
4
dot1x default
This command sets all configurable dot1x global and port settings to their default
values.
Syntax
dot1x default
Command Mode
Global Configuration
Example
dot1x max-req
This command sets the maximum number of times the switch port will retransmit an
EAP request/identity packet to the client before it times out the authentication
session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
Console(config)#dot1x default
Console(config)#
Console(config)#interface ethernet 1/1
Console(config-if)#dot1x max-req 2
Console(config)#