Flash/File Commands
4-69
4
This example shows how to download a PoE controller file from a TFTP server.
Note: It is possible to download a PoE PD_Controller file to a non-PoE switch, doing so
will not cause any adverse effects.
This example shows how to copy a PoE controller file from another unit in the slack.
delete
Use this command to delete a file or image.
Syntax
delete filename
filename - Name of the configuration file or image name.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If the file type is used for system startup, then this file cannot be deleted.
• “Factory_Default_Config.cfg” cannot be deleted.
Example
This example shows how to delete the test2.cfg configuration file from flash memory.
Console#copy tftp file
TFTP server IP address: 10.3.4.50
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 3
Source file name: 7012_007.s19
Destination file name: P-test
Write to FLASH Programming.
Write to FLASH finish.
Success.
Console#
Console#copy file controller
Unit <1-2>: 2
Choose controller type:
1. P: 2. VDSL: 3. TBD <1-3>: 1
Source file name: P-test
Software downloading in progress, please wait...
Unit 1 done
Console#
Console#delete test2.cfg
Console#
To Next Page
Loading...
