Command Line Interface
4-46
4
logging host
This command adds a syslog server host IP address that will receive logging
messages. Use the no form to remove a syslog server host.
Syntax
[no] logging host host_ip_address
host_ip_address - The IP address of a syslog server.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• By using this command more than once you can build up a list of host IP
addresses.
• The maximum number of host IP addresses allowed is five.
Example
logging facility
This command sets the facility type for remote logging of syslog messages. Use the
no form to return the type to the default.
Syntax
[no] logging facility type
type - A number that indicates the facility used by the syslog server to
dispatch log messages to an appropriate service. (Range: 16-23)
Default Setting
23
Command Mode
Global Configuration
Command Usage
The command specifies the facility type tag sent in syslog messages. (See
RFC 3164.) This type has no effect on the kind of messages reported by the
switch. However, it may be used by the syslog server to sort messages or to
store messages in the corresponding database.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
Console(config)#logging facility 19
Console(config)#
To Next Page
Loading...
Need help?
General